C3604 DTC For Ford Explorer Ii
Ford Explorer Ii Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Ford Explorer Ii engine control system detects a problem, the computer stores the diagnostic trouble
code C3604 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3604 DTC For Ford Explorer Ii.
A good ground connection is also extremely important. C3604 Ford Explorer Ii engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C3604 Ford Explorer Ii DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 6 |
Vehicle Speed Control And Idle Control System |
| 0 |
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage |
| 4 |
Cruise Vehicle Speed/Set Speed Difference Too High |
When you turn on the ignition, the Service Engine Soon or Check Engine C3604 Ford Explorer Ii light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C3604 DTC For Ford Explorer Ii so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C3604!
You can also check other Ford car models :
|
The listed Ford models will give information about C3604 DTC.
|
