P0131 DTC For Toyota Mark Ii
Toyota Mark Ii Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Toyota Mark Ii engine control system detects a problem, the computer stores the diagnostic trouble
code P0131 in its memory.
To figure out what is wrong with your vehicle you must first extract the P0131 DTC For Toyota Mark Ii.
Another consequence of P0131 Toyota Mark Ii engine overheating may be a blown head gasket. Heat makes aluminum swell almost three times faster than cast iron. Thermal stress can distort the head and make it swell in areas that are hottest like those between exhaust valves in adjoining cylinders, and areas that have restricted coolant flow like the narrow area that separates the cylinders. The typical aluminum head swells most in the middle, which can crush the head gasket if the head gets too hot. This will usually cause the head gasket to leak compression between adjacent cylinders, or leak coolant into the cylinders.
P0131 Toyota Mark Ii DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 3 |
Low Coolant Circuit |
| 1 |
PCM Stack Overrun |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the P0131 Toyota Mark Ii code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Toyota car models :
|
The listed Toyota models will give information about P0131 DTC.
|
