P0136 DTC For Toyota Dyna
Toyota Dyna Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | V-Type Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Toyota Dyna engine control system detects a problem, the computer stores the diagnostic trouble
code P0136 in its memory.
To figure out what is wrong with your vehicle you must first extract the P0136 DTC For Toyota Dyna.
On 1999 and later P0136 Toyota Dyna engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
P0136 Toyota Dyna DTC Meaning
P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
0 |
SAE - Generic |
1 |
Fuel And Air Metering |
3 |
Low Coolant Circuit |
6 |
Transmission Control Module Reprogrammable Memory |
The rule of P0136 Toyota Dyna code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P0136. Likewise, overriding the OBD P0136 DTC For Toyota Dyna system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Toyota car models :
The listed Toyota models will give information about P0136 DTC.
|