P0714 Bmw 6er DTC Code | EngineDTC.com

Bmw 6er Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	Opposite Piston Engine
Engine Air Intake Process :	Turbocharged Engine

Your Bmw 6er engine control system detects a problem, the computer stores the diagnostic trouble code P0714 in its memory. To figure out what is wrong with your vehicle you must first extract the P0714 DTC For Bmw 6er.

On 1999 and later P0714 Bmw 6er engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

P0714 Bmw 6er DTC Meaning

P	Powertrain Code - Problem is related engine, transmission and emissions systems.
0	SAE - Generic
7	Ignition System Or Misfire
1	IC Circuit High Voltage
4	Cruise Vehicle Speed/Set Speed Difference Too High

If your vehicle failed a P0714 Bmw 6er test and the P0714 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P0714 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P0714 DTC For Bmw 6er: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.