P0798 DTC For Toyota Kluger
Toyota Kluger Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Toyota Kluger engine control system detects a problem, the computer stores the diagnostic trouble
code P0798 in its memory.
To figure out what is wrong with your vehicle you must first extract the P0798 DTC For Toyota Kluger.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check P0798 Toyota Kluger that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
P0798 Toyota Kluger DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 0 |
SAE - Generic |
| 7 |
Ignition System Or Misfire |
| 9 |
TP Sensor Learn Not Complete |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
If your vehicle failed a P0798 Toyota Kluger test and the P0798 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P0798 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P0798 DTC For Toyota Kluger: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Toyota car models :
|
The listed Toyota models will give information about P0798 DTC.
|
