P0C6A DTC For Ford Consul
Ford Consul Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | V-Type Engine |
Engine Air Intake Process : | Naturally Aspirated |
Your Ford Consul engine control system detects a problem, the computer stores the diagnostic trouble
code P0C6A in its memory.
To figure out what is wrong with your vehicle you must first extract the P0C6A DTC For Ford Consul.
P0C6A Ford Consul engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
P0C6A Ford Consul DTC Meaning
P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
0 |
SAE - Generic |
C |
Transmission |
6 |
Vehicle Speed Output Circuit |
A |
TFP Valve Position Switch-Drive Without Drive Ratio |
The rule of P0C6A Ford Consul code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P0C6A. Likewise, overriding the OBD P0C6A DTC For Ford Consul system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Ford car models :
The listed Ford models will give information about P0C6A DTC.
|