P10E6 DTC For Ferrari 288
Ferrari 288 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Ferrari 288 engine control system detects a problem, the computer stores the diagnostic trouble
code P10E6 in its memory.
To figure out what is wrong with your vehicle you must first extract the P10E6 DTC For Ferrari 288.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check P10E6 Ferrari 288 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
P10E6 Ferrari 288 DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 1 |
MFG - Manufacturer Specific |
| 0 |
Transmission |
| E |
BBV Sensor Circuit Low Voltage |
| 6 |
Transmission Control Module Reprogrammable Memory |
The rule of P10E6 Ferrari 288 code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P10E6. Likewise, overriding the OBD P10E6 DTC For Ferrari 288 system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.
You can also check other Ferrari car models :
|
The listed Ferrari models will give information about P10E6 DTC.
|
