P173E DTC For Ford Zx2
Ford Zx2 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ford Zx2 engine control system detects a problem, the computer stores the diagnostic trouble
code P173E in its memory.
To figure out what is wrong with your vehicle you must first extract the P173E DTC For Ford Zx2.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check P173E Ford Zx2 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
P173E Ford Zx2 DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 1 |
MFG - Manufacturer Specific |
| 7 |
Ignition System Or Misfire |
| 3 |
Low Coolant Circuit |
| E |
TFP Valve Position Switch-Drive Without Drive Ratio |
If your vehicle failed a P173E Ford Zx2 test and the P173E Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P173E a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P173E DTC For Ford Zx2: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about P173E DTC.
|
