P196E DTC For Sunbeam 10
Sunbeam 10 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Sunbeam 10 engine control system detects a problem, the computer stores the diagnostic trouble
code P196E in its memory.
To figure out what is wrong with your vehicle you must first extract the P196E DTC For Sunbeam 10.
P196E Sunbeam 10 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
P196E Sunbeam 10 DTC Meaning
| P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
| 1 |
MFG - Manufacturer Specific |
| 9 |
Transmission |
| 6 |
Vehicle Speed Output Circuit |
| E |
TFP Valve Position Switch-Drive Without Drive Ratio |
If your P196E Sunbeam 10 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P196E and engine control unit are in charge of monitoring a bunch of different P196E DTC For Sunbeam 10, and if they get a reading that's a little out of whack, up pops the check engine light.
You can also check other Sunbeam car models :
|
The listed Sunbeam models will give information about P196E DTC.
|
