P3243 Sunbeam Rapier DTC Code

Sunbeam Rapier Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	V-Type Engine
Engine Air Intake Process :	Naturally Aspirated

Your Sunbeam Rapier engine control system detects a problem, the computer stores the diagnostic trouble code P3243 in its memory. To figure out what is wrong with your vehicle you must first extract the P3243 DTC For Sunbeam Rapier.

A good ground connection is also extremely important. P3243 Sunbeam Rapier engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).

P3243 Sunbeam Rapier DTC Meaning

P	Powertrain Code - Problem is related engine, transmission and emissions systems.
3	SAE - Generic
2	Computer And Auxiliary Outputs
4	Control Module Throttle Actuator Position Performance
3	TFP Valve Position Switch-Drive Without Drive Ratio

The rule of P3243 Sunbeam Rapier code when it comes to emissions-related vehicle repair is that any modification that changes the vehicle from a certified configuration to a non-certified configuration is considered tampering: this applies to both vehicle owners and repair facilities and is, therefore, a Federal offense. Replacing a catalyst with a straight pipe is one traditional example of P3243. Likewise, overriding the OBD P3243 DTC For Sunbeam Rapier system through the use of high-tech defeat devices or non-certified computer chips, for example, would also be considered tampering. The OBD system may, however, be repaired back to its original certified configuration with certified performance chips or appropriate aftermarket parts.