P338E DTC For Toyota Paseo

Toyota Paseo Engine Specifications:
Engine Type :Multi-Cylinder Engine
Cylinder Type :Opposed Cylinder Engine
Engine Air Intake Process :Naturally Aspirated

Your Toyota Paseo engine control system detects a problem, the computer stores the diagnostic trouble code P338E in its memory. To figure out what is wrong with your vehicle you must first extract the P338E DTC For Toyota Paseo.

On 1999 and later P338E Toyota Paseo engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.

P338E Toyota Paseo DTC Meaning

P Powertrain Code - Problem is related engine, transmission and emissions systems.
3 SAE - Generic
3 IC Module 4X Ref Circuit Intermittent, No Pulses
8 Crankshaft Position Sensor Circuit Performance
E TFP Valve Position Switch-Drive Without Drive Ratio

When you turn on the ignition, the Service Engine Soon or Check Engine P338E Toyota Paseo light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If P338E DTC For Toyota Paseo so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the P338E!

P338D DTC (Previous DTC Code) ( Next DTC Code ) P338F DTC
You can also check other Toyota car models :
The listed Toyota models will give information about P338E DTC.