U0351 DTC For Ford E 250
Ford E 250 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ford E 250 engine control system detects a problem, the computer stores the diagnostic trouble
code U0351 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0351 DTC For Ford E 250.
To solve U0351 Ford E 250 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
U0351 Ford E 250 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 0 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 5 |
BBV Sensor Circuit Low Voltage |
| 1 |
PCM Stack Overrun |
If your vehicle failed a U0351 Ford E 250 test and the U0351 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U0351 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U0351 DTC For Ford E 250: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U0351 DTC.
|
