U0386 DTC For Ford Mondeo 3
Ford Mondeo 3 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | In-Line Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Ford Mondeo 3 engine control system detects a problem, the computer stores the diagnostic trouble
code U0386 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0386 DTC For Ford Mondeo 3.
On 1999 and later U0386 Ford Mondeo 3 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
U0386 Ford Mondeo 3 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 0 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 8 |
Crankshaft Position Sensor Circuit Performance |
| 6 |
Transmission Control Module Reprogrammable Memory |
The U0386 Ford Mondeo 3 Check Engine lamp is perhaps the most troubling of lights because it could mean so many different things, from you didn't screw the gas cap on tightly enough to look out for pistons flying through the hood and into the stratosphere. The easiest way to find out what this light is telling you is to hook your vehicle up to a scan tool. U0386 diagnostic tool looks a little like an oversized calculator and plugs into a communication port inside the car. After you instruct it to perform the scan, it speaks U0386 DTC For Ford Mondeo 3 with your car's computers to find out exactly what's prompting the light to turn on.
You can also check other Ford car models :
|
The listed Ford models will give information about U0386 DTC.
|
