U0748 DTC For Mercedes Benz 260
Mercedes Benz 260 Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposed Cylinder Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Mercedes Benz 260 engine control system detects a problem, the computer stores the diagnostic trouble
code U0748 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0748 DTC For Mercedes Benz 260.
A good ground connection is also extremely important. U0748 Mercedes Benz 260 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
U0748 Mercedes Benz 260 DTC Meaning
U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
0 |
SAE - Generic |
7 |
Ignition System Or Misfire |
4 |
Control Module Throttle Actuator Position Performance |
8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the U0748 Mercedes Benz 260 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Mercedes car models :
The listed Mercedes models will give information about U0748 DTC.
|