U0930 DTC For Jensen Interceptor
Jensen Interceptor Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposite Piston Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Jensen Interceptor engine control system detects a problem, the computer stores the diagnostic trouble
code U0930 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0930 DTC For Jensen Interceptor.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check U0930 Jensen Interceptor that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
U0930 Jensen Interceptor DTC Meaning
U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
0 |
SAE - Generic |
9 |
Transmission |
3 |
Low Coolant Circuit |
0 |
Transmission Engaged At High Throttle Angle |
If your vehicle failed a U0930 Jensen Interceptor test and the U0930 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U0930 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U0930 DTC For Jensen Interceptor: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Jensen car models :
The listed Jensen models will give information about U0930 DTC.
|