U0931 DTC For Jensen Cv8
Jensen Cv8 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Jensen Cv8 engine control system detects a problem, the computer stores the diagnostic trouble
code U0931 in its memory.
To figure out what is wrong with your vehicle you must first extract the U0931 DTC For Jensen Cv8.
U0931 Jensen Cv8 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
U0931 Jensen Cv8 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 0 |
SAE - Generic |
| 9 |
Transmission |
| 3 |
Low Coolant Circuit |
| 1 |
PCM Stack Overrun |
If your vehicle failed a U0931 Jensen Cv8 test and the U0931 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U0931 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U0931 DTC For Jensen Cv8: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Jensen car models :
|
The listed Jensen models will give information about U0931 DTC.
|
