U1000 DTC For Ford Probe
Ford Probe Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Ford Probe engine control system detects a problem, the computer stores the diagnostic trouble
code U1000 in its memory.
To figure out what is wrong with your vehicle you must first extract the U1000 DTC For Ford Probe.
To solve U1000 Ford Probe problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
U1000 Ford Probe DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 1 |
MFG - Manufacturer Specific |
| 0 |
Transmission |
| 0 |
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage |
| 0 |
Transmission Engaged At High Throttle Angle |
If your vehicle failed a U1000 Ford Probe test and the U1000 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U1000 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U1000 DTC For Ford Probe: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U1000 DTC.
|
