U1026 DTC For Ford Explorer V
Ford Explorer V Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposite Piston Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Ford Explorer V engine control system detects a problem, the computer stores the diagnostic trouble
code U1026 in its memory.
To figure out what is wrong with your vehicle you must first extract the U1026 DTC For Ford Explorer V.
U1026 Ford Explorer V engine diagnostic code is about in terms of how often you should get your tyres rotated, it's different for every vehicle and type of tyre, but having them rotated at every oil change is a good rule of thumb. Check with the tyre manufacturer for a more specific time frame. Remember that the more often you rotate your tyres, the more evenly they'll wear, and when you have the tyres rotated, you should also get them checked for balance and alignment.
U1026 Ford Explorer V DTC Meaning
U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
1 |
MFG - Manufacturer Specific |
0 |
Transmission |
2 |
Cruise Control Servo Indicates Low |
6 |
Transmission Control Module Reprogrammable Memory |
If your vehicle failed a U1026 Ford Explorer V test and the U1026 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U1026 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U1026 DTC For Ford Explorer V: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
The listed Ford models will give information about U1026 DTC.
|