U2010 DTC For Ford F 650
Ford F 650 Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposite Piston Engine |
Engine Air Intake Process : | Turbocharged Engine |
Your Ford F 650 engine control system detects a problem, the computer stores the diagnostic trouble
code U2010 in its memory.
To figure out what is wrong with your vehicle you must first extract the U2010 DTC For Ford F 650.
U2010 Ford F 650 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
U2010 Ford F 650 DTC Meaning
U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
2 |
MFG - Manufacturer Specific |
0 |
Transmission |
1 |
IC Circuit High Voltage |
0 |
Transmission Engaged At High Throttle Angle |
If your vehicle failed a U2010 Ford F 650 test and the U2010 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U2010 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U2010 DTC For Ford F 650: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
The listed Ford models will give information about U2010 DTC.
|