U205E DTC For Ford Explorer Iv
Ford Explorer Iv Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Ford Explorer Iv engine control system detects a problem, the computer stores the diagnostic trouble
code U205E in its memory.
To figure out what is wrong with your vehicle you must first extract the U205E DTC For Ford Explorer Iv.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check U205E Ford Explorer Iv that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
U205E Ford Explorer Iv DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 2 |
MFG - Manufacturer Specific |
| 0 |
Transmission |
| 5 |
BBV Sensor Circuit Low Voltage |
| E |
TFP Valve Position Switch-Drive Without Drive Ratio |
If your vehicle failed a U205E Ford Explorer Iv test and the U205E Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U205E a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U205E DTC For Ford Explorer Iv: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U205E DTC.
|
