U20UD Isuzu Kai DTC Code

Isuzu Kai Engine Specifications:

Engine Type :	Single Cylinder Engine
Cylinder Type :	Opposite Piston Engine
Engine Air Intake Process :	Naturally Aspirated

Your Isuzu Kai engine control system detects a problem, the computer stores the diagnostic trouble code U20UD in its memory. To figure out what is wrong with your vehicle you must first extract the U20UD DTC For Isuzu Kai.

To solve U20UD Isuzu Kai problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs

U20UD Isuzu Kai DTC Meaning

U	Network Code - Problem is climate control system, lighting, airbags, etc.
2	MFG - Manufacturer Specific
0	Transmission
U	BBV Sensor Circuit Low Voltage
D	TFP Valve Position Switch-Drive Without Drive Ratio

If your vehicle failed a U20UD Isuzu Kai test and the U20UD Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U20UD a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U20UD DTC For Isuzu Kai: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.