U3046 DTC For Ford Ecosport 2
Ford Ecosport 2 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ford Ecosport 2 engine control system detects a problem, the computer stores the diagnostic trouble
code U3046 in its memory.
To figure out what is wrong with your vehicle you must first extract the U3046 DTC For Ford Ecosport 2.
To solve U3046 Ford Ecosport 2 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
U3046 Ford Ecosport 2 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 3 |
SAE - Generic |
| 0 |
Transmission |
| 4 |
Control Module Throttle Actuator Position Performance |
| 6 |
Transmission Control Module Reprogrammable Memory |
If your vehicle failed a U3046 Ford Ecosport 2 test and the U3046 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U3046 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U3046 DTC For Ford Ecosport 2: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U3046 DTC.
|
