U3048 DTC For Ford Tickford
Ford Tickford Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ford Tickford engine control system detects a problem, the computer stores the diagnostic trouble
code U3048 in its memory.
To figure out what is wrong with your vehicle you must first extract the U3048 DTC For Ford Tickford.
To solve U3048 Ford Tickford problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
U3048 Ford Tickford DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 3 |
SAE - Generic |
| 0 |
Transmission |
| 4 |
Control Module Throttle Actuator Position Performance |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
If your vehicle failed a U3048 Ford Tickford test and the U3048 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U3048 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U3048 DTC For Ford Tickford: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U3048 DTC.
|
