U3325 DTC For Datsun 280
Datsun 280 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Datsun 280 engine control system detects a problem, the computer stores the diagnostic trouble
code U3325 in its memory.
To figure out what is wrong with your vehicle you must first extract the U3325 DTC For Datsun 280.
U3325 Datsun 280 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
U3325 Datsun 280 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 3 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 2 |
Cruise Control Servo Indicates Low |
| 5 |
Cruise Inhibit Control Circuit |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the U3325 Datsun 280 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Datsun car models :
|
The listed Datsun models will give information about U3325 DTC.
|
