U3394 DTC For Bmw 428
Bmw 428 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Bmw 428 engine control system detects a problem, the computer stores the diagnostic trouble
code U3394 in its memory.
To figure out what is wrong with your vehicle you must first extract the U3394 DTC For Bmw 428.
Do you have fresh, clean fuel in the tank? If it's empty, fill it up and go! If it's full, check U3394 Bmw 428 that the fuel shut-off valve is open and that it is clean. Stale fuel, dirt and debris are the most common cause of outdoor power equipment not starting properly. If you store equipment with untreated gas in the tank, it can lead to engine damage.
U3394 Bmw 428 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 3 |
SAE - Generic |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 9 |
TP Sensor Learn Not Complete |
| 4 |
Cruise Vehicle Speed/Set Speed Difference Too High |
If your vehicle failed a U3394 Bmw 428 test and the U3394 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U3394 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U3394 DTC For Bmw 428: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Bmw car models :
|
The listed Bmw models will give information about U3394 DTC.
|
