C0052 DTC For Caterham R300
Caterham R300 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Caterham R300 engine control system detects a problem, the computer stores the diagnostic trouble
code C0052 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0052 DTC For Caterham R300.
A good ground connection is also extremely important. C0052 Caterham R300 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0052 Caterham R300 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 0 |
Transmission |
| 5 |
BBV Sensor Circuit Low Voltage |
| 2 |
Kick-Down Switch Failed Short |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C0052 Caterham R300 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Caterham car models :
|
The listed Caterham models will give information about C0052 DTC.
|
