C3250 DTC For Bmw B10
Bmw B10 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | V-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Bmw B10 engine control system detects a problem, the computer stores the diagnostic trouble
code C3250 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3250 DTC For Bmw B10.
C3250 Bmw B10 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
C3250 Bmw B10 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 2 |
Computer And Auxiliary Outputs |
| 5 |
BBV Sensor Circuit Low Voltage |
| 0 |
Transmission Engaged At High Throttle Angle |
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C3250 Bmw B10 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
You can also check other Bmw car models :
|
The listed Bmw models will give information about C3250 DTC.
|
