DF200 DTC For Renault 5
Renault 5 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Renault 5 engine control system detects a problem, the computer stores the diagnostic trouble
code DF200 in its memory.
To figure out what is wrong with your vehicle you must first extract the DF200 DTC For Renault 5.
To solve DF200 Renault 5 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
DF200 Renault 5 DTC Meaning
| D |
Chassis Code - Problem is controller area network wiring bus and modules. |
| F |
SAE - Generic |
| 2 |
Computer And Auxiliary Outputs |
| 0 |
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage |
| 0 |
Transmission Engaged At High Throttle Angle |
If your vehicle failed a DF200 Renault 5 test and the DF200 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses DF200 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look DF200 DTC For Renault 5: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Renault car models :
|
The listed Renault models will give information about DF200 DTC.
|
