C0130 DTC For Subaru Legacy 3
Subaru Legacy 3 Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Subaru Legacy 3 engine control system detects a problem, the computer stores the diagnostic trouble
code C0130 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0130 DTC For Subaru Legacy 3.
On 1999 and later C0130 Subaru Legacy 3 engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
C0130 Subaru Legacy 3 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 3 |
Low Coolant Circuit |
| 0 |
Transmission Engaged At High Throttle Angle |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C0130 Subaru Legacy 3 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Subaru car models :
|
The listed Subaru models will give information about C0130 DTC.
|
