C0142 DTC For Rambler Custom
Rambler Custom Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Rambler Custom engine control system detects a problem, the computer stores the diagnostic trouble
code C0142 in its memory.
To figure out what is wrong with your vehicle you must first extract the C0142 DTC For Rambler Custom.
A good ground connection is also extremely important. C0142 Rambler Custom engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C0142 Rambler Custom DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 0 |
SAE - Generic |
| 1 |
Fuel And Air Metering |
| 4 |
Control Module Throttle Actuator Position Performance |
| 2 |
Kick-Down Switch Failed Short |
If your C0142 Rambler Custom check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system C0142 and engine control unit are in charge of monitoring a bunch of different C0142 DTC For Rambler Custom, and if they get a reading that's a little out of whack, up pops the check engine light.
You can also check other Rambler car models :
|
The listed Rambler models will give information about C0142 DTC.
|
