C1373 DTC For Toyota Sprinter
Toyota Sprinter Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | W-Type Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Toyota Sprinter engine control system detects a problem, the computer stores the diagnostic trouble
code C1373 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1373 DTC For Toyota Sprinter.
A good ground connection is also extremely important. C1373 Toyota Sprinter engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C1373 Toyota Sprinter DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 7 |
Exhaust Gas Recirculation System Valve 1 |
| 3 |
TFP Valve Position Switch-Drive Without Drive Ratio |
There are currently two main types of cylinder deactivation used today, depending on the type of engine. C1373 Toyota Sprinter code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1373 DTC.
|
