C2898 DTC For Mercedes Benz 170
Mercedes Benz 170 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Naturally Aspirated |
Your Mercedes Benz 170 engine control system detects a problem, the computer stores the diagnostic trouble
code C2898 in its memory.
To figure out what is wrong with your vehicle you must first extract the C2898 DTC For Mercedes Benz 170.
C2898 Mercedes Benz 170 engine problem can be occur defective fan clutches are a common and often overlooked cause of engine overheating. The shear characteristics of the clutch fluid gradually deteriorates over time, with an average loss in drive efficiency of about 200 rpm per year. Eventually slippage reaches the point where effective cooling is no longer possible and overheating results. (On average, the life of a fan clutch is about the same as a water pump. If one needs to be replaced, the other usually does too.)
C2898 Mercedes Benz 170 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 2 |
MFG - Manufacturer Specific |
| 8 |
Accelerator Pedal Position (APP) Sensor 1 Performance |
| 9 |
TP Sensor Learn Not Complete |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the C2898 Mercedes Benz 170 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.
You can also check other Mercedes car models :
|
The listed Mercedes models will give information about C2898 DTC.
|
