C3643 DTC For Ford 427
Ford 427 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Supercharged Engine |
Your Ford 427 engine control system detects a problem, the computer stores the diagnostic trouble
code C3643 in its memory.
To figure out what is wrong with your vehicle you must first extract the C3643 DTC For Ford 427.
To solve C3643 Ford 427 problem, you'll have to remove the muffler, crankcase and other components blocking the valve chamber. Then, remove the cylinder head bolts (label for easy re-installation) Adjust the jaws of the valve spring compressor until they touch the top and bottom of the valve chamber Push the tool in to compress the spring and tighten the jaws Remove the retainers and lift out the valves , compressors and springs
C3643 Ford 427 DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 3 |
SAE - Generic |
| 6 |
Vehicle Speed Control And Idle Control System |
| 4 |
Control Module Throttle Actuator Position Performance |
| 3 |
TFP Valve Position Switch-Drive Without Drive Ratio |
If your vehicle failed a C3643 Ford 427 test and the C3643 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses C3643 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look C3643 DTC For Ford 427: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about C3643 DTC.
|
