P10E2 DTC For Toyota Rs
Toyota Rs Engine Specifications:
Engine Type : | Single Cylinder Engine |
Cylinder Type : | Opposite Piston Engine |
Engine Air Intake Process : | Supercharged Engine |
Your Toyota Rs engine control system detects a problem, the computer stores the diagnostic trouble
code P10E2 in its memory.
To figure out what is wrong with your vehicle you must first extract the P10E2 DTC For Toyota Rs.
On 1999 and later P10E2 Toyota Rs engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
P10E2 Toyota Rs DTC Meaning
P |
Powertrain Code - Problem is related engine, transmission and emissions systems. |
1 |
MFG - Manufacturer Specific |
0 |
Transmission |
E |
BBV Sensor Circuit Low Voltage |
2 |
Kick-Down Switch Failed Short |
If your vehicle failed a P10E2 Toyota Rs test and the P10E2 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P10E2 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P10E2 DTC For Toyota Rs: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Toyota car models :
The listed Toyota models will give information about P10E2 DTC.
|