C1348 DTC For Toyota Denso
Toyota Denso Engine Specifications:
| Engine Type : | Multi-Cylinder Engine |
| Cylinder Type : | Opposed Cylinder Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Toyota Denso engine control system detects a problem, the computer stores the diagnostic trouble
code C1348 in its memory.
To figure out what is wrong with your vehicle you must first extract the C1348 DTC For Toyota Denso.
A good ground connection is also extremely important. C1348 Toyota Denso engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
C1348 Toyota Denso DTC Meaning
| C |
Chassis Code - Problem is controller area network wiring bus and modules. |
| 1 |
MFG - Manufacturer Specific |
| 3 |
IC Module 4X Ref Circuit Intermittent, No Pulses |
| 4 |
Control Module Throttle Actuator Position Performance |
| 8 |
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit |
When you turn on the ignition, the Service Engine Soon or Check Engine C1348 Toyota Denso light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C1348 DTC For Toyota Denso so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C1348!
You can also check other Toyota car models :
|
The listed Toyota models will give information about C1348 DTC.
|
