U1014 DTC For Ford 49
Ford 49 Engine Specifications:
| Engine Type : | Single Cylinder Engine |
| Cylinder Type : | Opposite Piston Engine |
| Engine Air Intake Process : | Turbocharged Engine |
Your Ford 49 engine control system detects a problem, the computer stores the diagnostic trouble
code U1014 in its memory.
To figure out what is wrong with your vehicle you must first extract the U1014 DTC For Ford 49.
A good ground connection is also extremely important. U1014 Ford 49 engine problem because the presence of voltage at the panel harness won't make the panel work if there is a bad ground connection. Since the instrument cluster is mounted in a plastic dash, a separate ground wire or ground circuit through the wiring harness is usually needed to complete the power circuit. Refer again to the wiring diagram to find the ground path, and then check it with your ohmmeter. Do not use a self-powered test light because it cannot measure resistance (any resistance will lower circuit voltage).
U1014 Ford 49 DTC Meaning
| U |
Network Code - Problem is climate control system, lighting, airbags, etc. |
| 1 |
MFG - Manufacturer Specific |
| 0 |
Transmission |
| 1 |
IC Circuit High Voltage |
| 4 |
Cruise Vehicle Speed/Set Speed Difference Too High |
If your vehicle failed a U1014 Ford 49 test and the U1014 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses U1014 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look U1014 DTC For Ford 49: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
You can also check other Ford car models :
|
The listed Ford models will give information about U1014 DTC.
|
